Buhler Farm king FK329 User Manual download pdf (Page 8)

#1080 Snowblower

- 6 -

ASSEMBLY INSTRUCTIONS - Cont'd.

4. Mounting blower on Tractor:

a) Mount the blower on a tractor with a category 2 or 3 standard hitch or a

category 3 quick hitch. The hitch has two holes both at the top of the hitch

and at each lift arm. When using a quick coupler, the pins must be in the

inside set of holes. Use the outside set of holes with a standard three-

point hitch. The lift arm pins also have a narrow spacing for category 2

and a wide spacing for category 3.

b) Using tape or a bright colored marking pen, mark on the outer shields of

the PTO the position where the shaft is completely pushed together and

the position where you have a 4" overlap. Watch these marks when

moving the blower through all possible operating angles to see that the

PTO shaft stays within this range. Slide the hitch in if necessary to keep

the PTO shaft in this operating range. Do not forget to change the

position of the cylinder arm (#17) by the same distance that you move the

hitch.

c) With the engine on the tractor shut off, attach the PTO shaft. The tractor

end has a 1 3/8" 21 spline end with a spring loaded locking collar. The

snowblower end has a clamp style yoke with a 3/8” keyway. Slide the

yoke onto the 1 ¾” jackshaft with the 3/8" key supplied. Lock the yoke in

place with the 5/8" x 3 ¼” bolt and lock nut fitted through the groove in the

gearbox shaft. After tightening the bolt, insert and tighten the 3/8 socket

set screw supplied.

d) Always check to see that both ends of the PTO shaft are securely

attached every time the snowblower is used. This should always be done

with the tractor engine off.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

Buhler Farm king FK329 User Manual Page 8