bühler
bühlerbühler
bühler
2500 Hayliner
10
OPERATION
CAUTION Prior to operation ensure the operator has read and
understands the safety requirements of the 2500 Hayliner. Ensure the pre-operation
checks have been completed prior to operation.
1. Attaching Bale Carrier To Tractor
CAUTION Shut off tractor, engage parking brake and remove key before
working around 2500 Hayliner. Refer to tractor manual for tractor parking procedures.
CAUTION Use only the drawbar to couple the 2500 Hayliner to the
tractor. Ensure drawbar is capable of handling the 2500 Hayliner load. The tractor must
have a minimum mass of 25000 LB (11340 kg) and recommended 100 hp (75 kw).
Using the tongue jack, raise tongue to align with hitch pin, adjust clevis position
as necessary to level the carrier beams.
Position tractor and secure with locking type drawbar pin (not supplied). Use an
approved hitch pin with a mechanical retainer.
Route safety chain around the hitch clevis, around drawbar support and back
hook. Refer to tractor manual for further drawbar instructions.
Do not use intermediate support on drawbar as attaching point.
Store safety chain off the ground when not in use. If safety chain is damaged in
any way, contact your dealer for a replacement.
2. Attaching Bale Carrier Controls To Tractor
Bale raise and push functions are controlled by the 2500 Hayliner valve.
Pressure and tank are supplied by two hoses complete with black hydraulic tip
covers. The retract hose is designated with a check valve and ensures proper
flow through the valve. Connect tank hose to retract circuit and extend hose to
opposite extend port see Appendix B for schematic.
The tilt function is controlled by the tractor’s remote valve. Extension and
retraction are supplied by two hoses complete with red hydraulic tip covers.
Connect control handle harness to the machine harness. Connection is made at
the snubber unit by matching the appropriate socket and plug.
Power to operate the 2500 Hayliner is supplied by the tractors 12 volt electrical
system. Connect the red wire to the tractor positive and green to tractor ground.
Connection may be made via tractor accessory plug or alternate method. The 15
amp fuse must be used on the positive wire as supplied.
Verify 2500 Hayliner operation matches 2500 Hayliner control handle decal.
(74 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals