Buhler Inland 2500 Specifications download pdf (Page 15)

bühler

bühlerbühler

bühler

2500 Hayliner

LUBRICATION

CAUTION Place all controls in neutral, stop engine, set parking brake

and remove ignition key before inspecting, servicing, adjusting or repairing the 2500

Hayliner.

CAUTION Ensure the 2500 Hayliner tires and hitch are securely block.

Otherwise, verify the 2500 Hayliner is properly coupled to the drawbar on a tractor with

a minimum mass of 25000 LB (11340 kg).

Pivot Points

 Lubricate 2500 Hayliner bushings and pivots every eight hours of average

operation with high-grade grease at all fitting locations. Select grease based on

the expected outside temperature range. Lithium, Molybdenum and synthetic

greases are preferred. Use the tractor hour meter as a guide. Increase lubrication

intervals for extreme use or adverse conditions. Each pivot should be lubricated

until grease is visible at pin. The fixed arm carrier has 16 lubrication points and

the RPU carrier has 18 points. Refer to the illustrations below for locations.

RPU PIVOT LEFT

AND RIGHT SIDES

RPU LUBRICATION

ILLUSTRATION

AXLE BEARING

HYDRAULIC CYLINDER END

BUSHING

HYDRAULIC CYL

END

LUBRICATION ILLUSTRATION

Roller Chain

 Manually brush an SAE lubricant while chain is stationary.

 Lubricate the chains every time bolt torque maintenance is performed.

Carrier Beams

 Apply a graphite coating such as Slip Plate

to the carrier beams as required to

ensure a smooth push back operation.

 Follow application instructions as provided by the coating manufacturer.

 At the end of the season apply a coating to prevent rust on the carrier beams.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 70 71

No comments

Buhler Inland 2500 Specifications Page 15