Buhler Inland 2500 Specifications download pdf (Page 23)

bühler

bühlerbühler

bühler

2500 Hayliner

23

Bale Deflector Arm Assembly

 Remove all hardware that is included with the

deflector assembly.

 Remove the two top bolts from outer fork on

lift arm.

 Maintain the spacing of the forks if already

preset. If not set spacing as described in the

fixed pick up arm assembly section.

 Insert the coned end of the deflector onto the

end of the outer fork.

 Align the bolt holes from the removed bolts

on the outer fork and the end of the deflector

attachment.

 Insert hardware supplied with the deflector

the same way the hardware was installed

before the attachment was added.

 Torque all hardware according to the bolt

chart and tighten the set screws on the cone

also according to the chart.

 During first bale lift, cycle slowly and watch

for excessive flexing or movement of the

deflector. If movement is detected stop cycle

and retorque all hardware involved.

BALE DEFLECTOR

ATTACHMENT ASSEMBLY

LAYOUT

RPU Assembly

 Remove lift cylinder and install Pilot Check

assembly (see Appendix B)

 Reinstall cylinder at base end only.

 Lubricate all pins involved in RPU attachment

with a SAE multi purpose grease.

 Align arm to pivots with open end of arm

facing away from the 2500 Hayliner and

reinstall pins with hardware provided and

torque to specifications called for in the bolt

chart.

 Remove the lift cylinder pin

from the RPU arm.

RPU ATTACHMENT

ASSEMBLY LAYOUT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 70 71

Comments to this Manuals

No comments